Also you can message us your car model to confirm it. Hold the hinge assembly up to the door jamb section of the. Pick a location that is the approximate middle of door. Important: Keep the hinge assembly as close to the.
Outer body skin as possible. The edge of the hinge square. Should be just up against the step in the jamb post. Applications will vary, but as a reference, there should be a.
Maximum of 1/4" to 3/8" distance from the outer body skin. To the edge of square cut outs. Important: In order to have the door open level, the. Hinge assembly should be perpendicular to the ground. Some cases, the top hinge may be at a different distance from.
The outer door skin than the bottom hinge. Bring the hinge assembly inside the vehicle and match the.Square holes with the square hinge tubing. Forward until the pivot pin is approximately one inch from the. Door jamb section of the body. This is a very critical step. Location of the pivot pin allows the door to push away from. The body as the door swings back. Important: The pivot point rests on the outer body skin. And is kept back approximately 1 from the door jamb. If this placement is not possible in. Your application, locate the hinge as close to it as possible. The swing arms will protrude from the door jamb into the. Door in a way that may not be flush with the inner door skin. If this is the case, it will be necessary to build recessed door. Pockets to match the swing arms to the door skin. Door up to the body and determine the location of the. Important: At this point, the hinge assembly should only. Be welded in place with tack-welds until the door can be.
If it isn't necessary to build recessed door pockets, you may. Disregard them and mount the swing arms to the inner door.Skin with the supplied backing plates two provided per side. Important: Tack-weld the door to the body with the. Desired door gap before attaching the swing arm to the inner. After door has been temporarily attached, push the.
Swing arm up to the inner door skin from inside the vehicle. At this point, mark the holes to be drilled for mounting the. Slightly over size the mounting holes to allow for future.
Cut door loose and check swing. Note that in some applications, the backing plate location. In the event the item should fail due to manufacturing defects during intended use, we will replace the part by free.
Product can expose you to chemicals including Chromium (Hexavalent Compounds). Which is known to the State of California to cause cancer, and birth defects or other reproductive harm.For more information, go to California goverment website, you can search California P65Warnings. Most of the items are after-market, so, no installation instruction will be included. For replacements, please notice us within 5 days after you receiving the item. We will try our best to serve you better! This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Interior Parts & Accessories\Steering Wheels & Horn Buttons". The seller is "autobrother" and is located in this country: US. This item can be shipped to United States.